Maxx Ice green and yellow lights flashing together: the cleaning cycle is running
Pressing CLEAN within three minutes of switching on puts LED-panel machines into automatic cleaning.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Maxx Ice
Book a visit
Three short steps, about a minute.
or call (844) 410-9163
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Green and yellow LEDs flashing together
actually means.
Pressing CLEAN within three minutes of switching on puts LED-panel machines into automatic cleaning. The green Ice Making and yellow Ice Harvest lights flash together for about 30 minutes, then stay on steady when cleaning is finished.
Maxx Ice ice machine display · also shown as Ice Making and Ice Harvest LEDs blinking
What to do when Green and yellow LEDs flashing together shows on the ice machineKind of codeMode, not a failure
Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.
Usually leads toNo repair
If you started a cleaning, let the 30 minutes finish.
Shows up asIce Machine Error Code or Flashing Light: What It Is Telling You
An ice machine error code may show as a number on a small display, a pattern of blinking lights on the control board, a colored light on the front, or a machine that stops with one indicator flashing.
MakeMaxx Ice
A Maxx Ice call opens with the location: room temperature, airflow around the unit and a drain that falls the way it should.
SourceMaxx Ice modular MIM452, MIM600, MIM1000 manual
LED-panel models including MIM452, MIM600, MIM1000, MIM250 and MIM80 to MIM125H. On the MIM250 and the MIM85H family, the sanitizing run uses a different pair of lights.
Before you book,
in this order.
Each step comes from Maxx Ice's own guidance for Green and yellow LEDs flashing together on its ice machines. Follow it to the end: the last card says whether this is a visit.
If you started a cleaning, let the 30 minutes finish.
If you did not mean to, press the power switch or the CLEAN button to stop it.
After cleaning, switch the machine off and on to go back to making ice.
If the lights keep flashing together without anyone pressing CLEAN, book a visit to check the control panel.
Cleared?
The light or code is gone, and the machine fills, freezes and drops a full batch of cubes into the bin with no new part. If it returns within a week, or the clean light comes back straight after a cleaning cycle, mention that in the booking.
What not to do
The two lights flashing together do not report a problem. A single green or yellow light flashing on its own has a different, model-specific meaning.
What you may
notice with it.
The ice machine problems Green and yellow LEDs flashing together tends to arrive with. Answer these at the ice machine before anyone is booked.
All problems
No repair indicated
Nothing to repair.
Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.
Maxx Ice
ice machines.
A Maxx Ice call opens with the location: room temperature, airflow around the unit and a drain that falls the way it should.
Maxx Ice ice machine repairMore Maxx Ice codes
Mode, not a failure on other makes
Modular ice machine
An ice-making head set on top of a separate storage bin or drink dispenser, cooled by air, water or a condenser on the roof, turning out hundreds of pounds of cubes a day.
Undercounter ice machine
A self-contained ice machine that makes and stores its own ice under a bar, a service counter or a kitchen island, from commercial units to clear-ice models in large homes.
In Maxx Ice's own words
The green and yellow LEDs flash together.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. LED-panel models including MIM452, MIM600, MIM1000, MIM250 and MIM80 to MIM125H. On the MIM250 and the MIM85H family, the sanitizing run uses a different pair of lights.
Maxx Ice Green and yellow LEDs flashing together ice machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Green and yellow LEDs flashing together.
Can I clear Green and yellow LEDs flashing together myself?
Why are the green and yellow lights on my Maxx Ice flashing at the same time?
How do I stop the cleaning cycle on my Maxx Ice?
My Maxx Ice lights stopped flashing and stay on. Is it done?
Back to your everyday
Still showing Green and yellow LEDs flashing together?
A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.