The small keypad of a stainless modular ice machine with one plain amber light lit beside its buttons, the ice machine's bin below it holding a full mound of clear cubes.

Monogram Time to Clean light: order cleaner, then descale

Monogram's reminder runs in two steps: the light comes on after about 5 months so you can order cleaner, and starts flashing after about 6 months when the cleaning is due.

(844) 410-9163

Mon–Sat, 8am–8pm

  • Mode, not a failure
  • No repair needed
  • Source: Monogram

Book a visit

Three short steps, about a minute.

or call (844) 410-9163

What Time to Clean
actually means.

Monogram's reminder runs in two steps: the light comes on after about 5 months so you can order cleaner, and starts flashing after about 6 months when the cleaning is due. During the cleaning cycle itself the light flashes too, slowly while cleaning and quickly with a beep when the machine is waiting for cleaner, then turns off when the cycle ends.

Monogram ice machine display · also shown as Time to Clean light, Time to Clean flashing

What to do when Time to Clean shows on the ice machine

Before you book,
in this order.

Each step comes from Monogram's own guidance for Time to Clean on its ice machines. Follow it to the end: the last card says whether this is a visit.

01

Order the cleaner named in your manual when the light first comes on steady.

02

When it flashes, turn icemaking off with the Power button, empty the bin, then hold Clean for 3 seconds and add cleaner when the machine asks for it.

03

Let the cycle run to the end (about 40 minutes on the nugget model, up to an hour on the clear-ice model), then flush and sanitize the bin as the manual describes.

04

If the light will not go out after a full cycle, book a visit.

Cleared?

The light or code is gone, and the machine fills, freezes and drops a full batch of cubes into the bin with no new part. If it returns within a week, or the clean light comes back straight after a cleaning cycle, mention that in the booking.

What not to do

Time to Clean does not stop ice production and is not a sign of a failed part. A machine that also shows other lights flashing has a separate issue that the cleaning will not fix.

No repair indicated

Nothing to repair.

Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.

In Monogram's own words

Indicator will turn on after 5 months indicating it is time to order cleaner.
Monogram UCC15NP clear-ice machine owner's manual (GE Appliances) Monogram UCC15NP clear-ice machine owner's manual (GE Appliances) Monogram UNC15NP nugget ice machine owner's manual 49-1000610

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Monogram UNC15NP nugget and UCC15NP clear-ice machines. The older ZDIS150 and ZDIC150 use a single Clean light that turns yellow, then red.

Monogram Time to Clean ice machine repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family filling glasses with nugget ice from an ice machine in a large home kitchen.
For the heart of your home.

Questions
about Time to Clean.

Can I clear Time to Clean myself?
Order the cleaner named in your manual when the light first comes on steady.
Why is the Monogram Time to Clean light on but not flashing?
That is the first step, at about 5 months: Monogram is telling you to order cleaner. The cleaning itself is due when the light starts flashing.
My Monogram beeped and the Time to Clean light flashed fast during cleaning. What does it want?
That is the machine asking for cleaner. Add the measured cleaner where the manual shows, then press Clean to continue.
Do I need to sanitize the bin after cleaning a Monogram ice machine?
Yes. After the cycle the manual has you flush the bin with hot water, wipe the bin and door with cleaner solution, sanitize with a weak bleach mix and rinse again.

Back to your everyday

Still showing Time to Clean?

A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.

(844) 410-9163 Schedule a repair