Scotsman code b: bin is full
Scotsman machines stop when the bin control reports ice at the set level, and the display shows b.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Scotsman
Book a visit
Three short steps, about a minute.
or call (844) 410-9163
Loading appointment form…
The appointment form couldn’t load. Please try again.
What b
actually means.
Scotsman machines stop when the bin control reports ice at the set level, and the display shows b. On a cuber with the optional ultrasonic level sensor, the level can be set lower than the bin top. The machine restarts on its own when ice is used.
Scotsman ice machine display
What to do when b shows on the ice machineKind of codeMode, not a failure
Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.
Usually leads toNo repair
Check the bin: if it is full, nothing is wrong.
Shows up asIce Machine Error Code or Flashing Light: What It Is Telling You
An ice machine error code may show as a number on a small display, a pattern of blinking lights on the control board, a colored light on the front, or a machine that stops with one indicator flashing.
MakeScotsman
A Scotsman visit sorts out which kind of ice the machine makes, because each kind follows a different service path.
SourceScotsman Prodigy ELITE modular cuber service manual, MC0322 through MC2148 (January 2022)
Prodigy and Prodigy ELITE cubers (MC and C models) show one character in the code display next to the lights. Prodigy flaked and nugget machines with the CM3 control (N and F models) use the same display with a different code list.
Before you book,
in this order.
Each step comes from Scotsman's own guidance for b on its ice machines. Follow it to the end: the last card says whether this is a visit.
Check the bin: if it is full, nothing is wrong.
If the bin is not full, check that ice is not piled up against the sensor or the curtain.
If b stays with an empty bin, book a visit to test the bin control.
Cleared?
The light or code is gone, and the machine fills, freezes and drops a full batch of cubes into the bin with no new part. If it returns within a week, or the clean light comes back straight after a cleaning cycle, mention that in the booking.
What not to do
b is not an error code; it is a normal state. It does not mean the machine has stopped for good.
What you may
notice with it.
The ice machine problems b tends to arrive with. Answer these at the ice machine before anyone is booked.
All problems
No repair indicated
Nothing to repair.
Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.
Scotsman
ice machines.
A Scotsman visit sorts out which kind of ice the machine makes, because each kind follows a different service path.
Scotsman ice machine repairMore Scotsman codes
Mode, not a failure on other makes
Modular ice machine
An ice-making head set on top of a separate storage bin or drink dispenser, cooled by air, water or a condenser on the roof, turning out hundreds of pounds of cubes a day.
Undercounter ice machine
A self-contained ice machine that makes and stores its own ice under a bar, a service counter or a kitchen island, from commercial units to clear-ice models in large homes.
Nugget ice machine
An ice machine that freezes a thin layer inside a chilled cylinder and pushes it out with an auger as soft, chewable nuggets, for clinics, offices, hotels and large homes.
In Scotsman's own words
Bin is Full
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Prodigy and Prodigy ELITE cubers (MC and C models) show one character in the code display next to the lights. Prodigy flaked and nugget machines with the CM3 control (N and F models) use the same display with a different code list.
Scotsman b ice machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about b.
Can I clear b myself?
My Scotsman shows b but the bin is half empty. Why?
How long does a Scotsman take to restart after b?
Is b the same as O on a Scotsman?
Back to your everyday
Still showing b?
A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.