The small keypad of a stainless modular ice machine with one plain amber light lit beside its buttons, the ice machine's bin below it holding a full mound of clear cubes.

Monogram ZDIS150 Clean light yellow or red: cleaning is due

These earlier Monogram machines use one light in two colors.

(844) 410-9163

Mon–Sat, 8am–8pm

  • Mode, not a failure
  • No repair needed
  • Source: Monogram

Book a visit

Three short steps, about a minute.

or call (844) 410-9163

What CLEAN light yellow / red
actually means.

These earlier Monogram machines use one light in two colors. Yellow says the control senses cleaning will soon be needed; red says it must be done, or production will drop sharply or stop. During the cleaning cycle itself the Clean light blinks for about 70 minutes, then stays on steady when the cycle is complete.

Monogram ice machine display · also shown as Clean light yellow, Clean light red, CLEAN blinking

What to do when CLEAN light yellow / red shows on the ice machine

Before you book,
in this order.

Each step comes from Monogram's own guidance for CLEAN light yellow / red on its ice machines. Follow it to the end: the last card says whether this is a visit.

01

On yellow, buy the nickel-safe ice machine cleaner the manual names.

02

On red, press and hold Off for 3 seconds, wait for the last ice to drop, empty the bin and drain the reservoir through its cap.

03

Refit the cap, add the full bottle of cleaner as the manual directs and start the cycle; if the light will not change after a full cycle, book a visit.

Cleared?

The light or code is gone, and the machine fills, freezes and drops a full batch of cubes into the bin with no new part. If it returns within a week, or the clean light comes back straight after a cleaning cycle, mention that in the booking.

What not to do

A yellow light is not a problem yet and the machine keeps making ice. A blinking Clean light is the cleaning cycle running, not a new warning.

What you may
notice with it.

The ice machine problems CLEAN light yellow / red tends to arrive with. Answer these at the ice machine before anyone is booked.

All problems

No repair indicated

Nothing to repair.

Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.

In Monogram's own words

The clean light signal will illuminate yellow when the electronic control senses that the need for cleaning is approaching.
Monogram ZDIC150 / ZDIS150 automatic icemaker owner's manual Monogram ZDIC150 / ZDIS150 automatic icemaker owner's manual Monogram ZDIC150 / ZDIS150 automatic icemaker owner's manual

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Monogram ZDIS150 and ZDIC150 clear-ice machines built from 2007 through 2014. The current UNC15NP and UCC15NP models use a separate Time to Clean light instead.

Monogram CLEAN light yellow / red ice machine repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family filling glasses with nugget ice from an ice machine in a large home kitchen.
For the heart of your home.

Questions
about CLEAN light yellow / red.

Can I clear CLEAN light yellow / red myself?
On yellow, buy the nickel-safe ice machine cleaner the manual names.
My Monogram ZDIS150 Clean light turned red. Will it stop making ice?
Monogram warns that output will drop sharply or stop if the machine is not cleaned, so run the cleaning cycle soon.
Which cleaner does the Monogram ZDIS150 ice machine need?
The manual calls for a nickel-safe ice machine cleaner and asks for the whole bottle per cycle.
How do I know the Monogram ZDIS150 cleaning cycle is finished?
The Clean light stops blinking and stays on steady after about 70 minutes.

Back to your everyday

Still showing CLEAN light yellow / red?

A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.

(844) 410-9163 Schedule a repair