Monogram Making Ice light flashing: the machine is finishing before it stops
Monogram's machines do not stop mid-batch when you turn icemaking off.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Monogram
Book a visit
Three short steps, about a minute.
or call (844) 410-9163
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Making Ice flashing
actually means.
Monogram's machines do not stop mid-batch when you turn icemaking off. The Making Ice light flashes while the current cycle completes and the tank drains, which Monogram says can take up to 20 minutes on the clear-ice model, and then the light goes out.
Monogram ice machine display · also shown as Making Ice light flashing, Icemaking light flashing
What to do when Making Ice flashing shows on the ice machineKind of codeMode, not a failure
Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.
Usually leads toNo repair
Wait for the light to stop flashing before unplugging, moving or winterizing the machine.
Shows up asIce Machine Error Code or Flashing Light: What It Is Telling You
An ice machine error code may show as a number on a small display, a pattern of blinking lights on the control board, a colored light on the front, or a machine that stops with one indicator flashing.
MakeMonogram
For a Monogram ice machine built into cabinetry, the technician plans access to the drain and water connections before pulling anything forward.
SourceMonogram UCC15NP clear-ice machine owner's manual (GE Appliances)
Monogram UCC15NP clear-ice (up to 20 minutes) and UNC15NP nugget (about 1 to 3 minutes) machines.
Before you book,
in this order.
Each step comes from Monogram's own guidance for Making Ice flashing on its ice machines. Follow it to the end: the last card says whether this is a visit.
Wait for the light to stop flashing before unplugging, moving or winterizing the machine.
If you must stop at once, press and hold Power for 3 seconds a second time, as the manual allows.
If the light flashes for much longer than 30 minutes, book a visit.
Cleared?
The light or code is gone, and the machine fills, freezes and drops a full batch of cubes into the bin with no new part. If it returns within a week, or the clean light comes back straight after a cleaning cycle, mention that in the booking.
What not to do
The flashing is not the water supply signal, which alternates Making Ice with the Filter light. It is also not a stuck harvest; the machine is finishing the batch on purpose.
What you may
notice with it.
The ice machine problems Making Ice flashing tends to arrive with. Answer these at the ice machine before anyone is booked.
All problems
No repair indicated
Nothing to repair.
Nothing is broken; the control is reporting a state someone chose or a routine it runs: a clean or sanitize reminder counting the hours since the last cycle, a delay of a few minutes after power returns before the pump and compressor start, a bin-full light while the bin control is satisfied, or a standby or off mode someone chose at the keypad. No part is needed; finishing the cycle the light asks for, waiting out the delay or the key sequence from the manual ends it.
Monogram
ice machines.
For a Monogram ice machine built into cabinetry, the technician plans access to the drain and water connections before pulling anything forward.
Monogram ice machine repairMore Monogram codes
Mode, not a failure on other makes
Undercounter ice machine
A self-contained ice machine that makes and stores its own ice under a bar, a service counter or a kitchen island, from commercial units to clear-ice models in large homes.
Nugget ice machine
An ice machine that freezes a thin layer inside a chilled cylinder and pushes it out with an auger as soft, chewable nuggets, for clinics, offices, hotels and large homes.
In Monogram's own words
will flash until the current icemaking cycle is complete prior to turning off.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Monogram UCC15NP clear-ice (up to 20 minutes) and UNC15NP nugget (about 1 to 3 minutes) machines.
Monogram Making Ice flashing ice machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Making Ice flashing.
Can I clear Making Ice flashing myself?
Why won't my Monogram ice machine turn off right away?
Is it bad to unplug a Monogram ice machine while the light is flashing?
How long should the Monogram Making Ice light flash?
Back to your everyday
Still showing Making Ice flashing?
A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.