Hoshizaki 6 beeps: supply voltage too low
Hoshizaki boards protect the unit from low voltage.
Mon–Sat, 8am–8pm
- Control board and power
- Ice machine control board repair
- Source: Hoshizaki
Book a visit
Three short steps, about a minute.
or call (844) 410-9163
Loading appointment form…
The appointment form couldn’t load. Please try again.
What 6 beeps
actually means.
Hoshizaki boards protect the unit from low voltage. When the supply falls to roughly 92 volts, the board stops the unit, sounds six beeps, and turns its power LED off. It resets itself once voltage is back to normal. Long extension cords, overloaded circuits and utility sags are the usual causes.
Hoshizaki ice machine display
What to do when 6 beeps shows on the ice machineKind of codeControl board and power
The board lost track of itself or of its power: a voltage too low or too high at startup, a relay that no longer closes, a keypad or display that stays dark, or a memory error after a surge. Switching off at the machine's own switch for a minute clears a passing glitch. A code that returns, a breaker that trips, or any hot or burning smell means the power stays off and the board, the wiring and the relays are left to a technician.
Usually leads toIce machine control board repair
The controller, its display, the sensors it reads and their wiring, tested when a code, a blinking light or a dead machine points there.
Shows up asIce Machine Error Code or Flashing Light: What It Is Telling You
An ice machine error code may show as a number on a small display, a pattern of blinking lights on the control board, a colored light on the front, or a machine that stops with one indicator flashing.
MakeHoshizaki
On a Hoshizaki ice machine, the technician notes every alarm signal and checks the water and condenser before pricing any part.
SourceHoshizaki KM-231BAJ and KM-301BAJ/BWJ self-contained crescent cuber service manual, No. 73238 (archived copy of hoshizakiamerica.com)
KM crescent cubers, both self-contained (KM-231, KM-301) and modular (KM-350 to KM-660), repeat the beep pattern from the control board inside the unit. DCM cubelet icemaker/dispensers (DCM-300, 500, 751, 752) repeat the beeps every five seconds and also light an orange ALARM LED; their beep list differs from the KM list.
Before you book,
in this order.
Each step comes from Hoshizaki's own guidance for 6 beeps on its ice machines. Follow it to the end: the last card says whether this is a visit.
Check that the unit is plugged straight into its own outlet, not an extension cord.
Note whether lights dim or other equipment stops at the same moment.
If six beeps keep returning, have an electrician check the circuit and book a visit for the unit.
Still there?
It usually turns into ice machine control board repair. Book with the code and the model number.
What not to do
Six beeps do not mean the board has failed; it is protecting itself. The alarm is not about the compressor, though low voltage is hard on it.
What you may
notice with it.
The ice machine problems 6 beeps tends to arrive with. Answer these at the ice machine before anyone is booked.
All problems
Where 6 beeps usually leads
Ice machine control board repair.
Hoshizaki
ice machines.
On a Hoshizaki ice machine, the technician notes every alarm signal and checks the water and condenser before pricing any part.
Hoshizaki ice machine repairMore Hoshizaki codes
Control board and power on other makes
Modular ice machine
An ice-making head set on top of a separate storage bin or drink dispenser, cooled by air, water or a condenser on the roof, turning out hundreds of pounds of cubes a day.
Undercounter ice machine
A self-contained ice machine that makes and stores its own ice under a bar, a service counter or a kitchen island, from commercial units to clear-ice models in large homes.
Nugget ice machine
An ice machine that freezes a thin layer inside a chilled cylinder and pushes it out with an auger as soft, chewable nuggets, for clinics, offices, hotels and large homes.
In Hoshizaki's own words
(92Vac±5% or less)
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. KM crescent cubers, both self-contained (KM-231, KM-301) and modular (KM-350 to KM-660), repeat the beep pattern from the control board inside the unit. DCM cubelet icemaker/dispensers (DCM-300, 500, 751, 752) repeat the beeps every five seconds and also light an orange ALARM LED; their beep list differs from the KM list.
Hoshizaki 6 beeps ice machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about 6 beeps.
Can I clear 6 beeps myself?
Why does my Hoshizaki beep six times when the walk-in cooler starts?
Do I need to reset my Hoshizaki after 6 beeps?
Why is the power LED off on my Hoshizaki during 6 beeps?
Back to your everyday
Still showing 6 beeps?
A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.