Hoshizaki 3 beeps: freeze ran past the freeze timer twice
A KM freeze ends when the float switch in the water tank drops as water turns to ice.
Mon–Sat, 8am–8pm
- Harvest and freeze cycle
- Ice machine harvest repair
- Source: Hoshizaki
Book a visit
Three short steps, about a minute.
or call (844) 410-9163
Loading appointment form…
The appointment form couldn’t load. Please try again.
What 3 beeps
actually means.
A KM freeze ends when the float switch in the water tank drops as water turns to ice. If the float never drops before the freeze timer setting, two cycles running, the board locks out with three beeps. Hoshizaki lists a float switch stuck up, an inlet valve or hot gas valve leaking by, a pump that is not pumping, a bad expansion valve, low charge, or a weak compressor.
Hoshizaki ice machine display
What to do when 3 beeps shows on the ice machineKind of codeHarvest and freeze cycle
A freeze ran longer than the board allows, or a harvest started and the ice never fell. Scale on the evaporator holds the sheet to the plate, a thickness probe crusted with minerals never signals, a hot gas valve that does not open leaves the plate cold, a harvest assist that does not push, or a water curtain that swings without tripping its switch all end in this family. A cleaning cycle run by the manual often clears it; a valve or a probe is a technician's job.
Usually leads toIce machine harvest repair
The hot gas valve, harvest assist, curtain switch and thickness probe that decide when a sheet of cubes is done and make it drop.
Shows up asIce Machine Error Code or Flashing Light: What It Is Telling You
An ice machine error code may show as a number on a small display, a pattern of blinking lights on the control board, a colored light on the front, or a machine that stops with one indicator flashing.
MakeHoshizaki
On a Hoshizaki ice machine, the technician notes every alarm signal and checks the water and condenser before pricing any part.
SourceHoshizaki KM-231BAJ and KM-301BAJ/BWJ self-contained crescent cuber service manual, No. 73238 (archived copy of hoshizakiamerica.com)
KM crescent cubers, both self-contained (KM-231, KM-301) and modular (KM-350 to KM-660), repeat the beep pattern from the control board inside the unit. DCM cubelet icemaker/dispensers (DCM-300, 500, 751, 752) repeat the beeps every five seconds and also light an orange ALARM LED; their beep list differs from the KM list.
Before you book,
in this order.
Each step comes from Hoshizaki's own guidance for 3 beeps on its ice machines. Follow it to the end: the last card says whether this is a visit.
Count the beeps: three means the freeze timer alarm on a KM.
Check that the water supply is on and the filter is not overdue, since a starving or overfilling tank upsets the float.
Book a visit; the float switch, valves and cooling system are checked with the panel off.
Still there?
It usually turns into ice machine harvest repair. Book with the code and the model number.
What not to do
On DCM cubelet dispensers, three beeps come from the high-pressure switch instead. On a KM this alarm is not the 1-beep high-temperature lockout.
What you may
notice with it.
The ice machine problems 3 beeps tends to arrive with. Answer these at the ice machine before anyone is booked.
All problems
Where 3 beeps usually leads
Ice machine harvest repair.
Hoshizaki
ice machines.
On a Hoshizaki ice machine, the technician notes every alarm signal and checks the water and condenser before pricing any part.
Hoshizaki ice machine repairMore Hoshizaki codes
Harvest and freeze cycle on other makes
Modular ice machine
An ice-making head set on top of a separate storage bin or drink dispenser, cooled by air, water or a condenser on the roof, turning out hundreds of pounds of cubes a day.
Undercounter ice machine
A self-contained ice machine that makes and stores its own ice under a bar, a service counter or a kitchen island, from commercial units to clear-ice models in large homes.
Nugget ice machine
An ice machine that freezes a thin layer inside a chilled cylinder and pushes it out with an auger as soft, chewable nuggets, for clinics, offices, hotels and large homes.
In Hoshizaki's own words
(freeze > freeze timer setting for two cycles in a row)
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. KM crescent cubers, both self-contained (KM-231, KM-301) and modular (KM-350 to KM-660), repeat the beep pattern from the control board inside the unit. DCM cubelet icemaker/dispensers (DCM-300, 500, 751, 752) repeat the beeps every five seconds and also light an orange ALARM LED; their beep list differs from the KM list.
Hoshizaki 3 beeps ice machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about 3 beeps.
Can I clear 3 beeps myself?
Can a dirty float switch cause 3 beeps on my Hoshizaki?
Why does my Hoshizaki keep filling water and then beep three times?
Is 3 beeps on a Hoshizaki dispenser the same alarm?
Back to your everyday
Still showing 3 beeps?
A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.