The inside top of an ice bin under a modular ice machine, the ice machine's bin control probe hanging just above a level mound of cubes, the bin door raised.

U-Line nugget ice machine with ICE and DRAIN blinking: air sensor

U-Line places an air sensor in front of the condenser so the control can adjust to the room.

(844) 410-9163

Mon–Sat, 8am–8pm

  • Sensors and bin control
  • Ice machine bin control repair
  • Source: U-Line

Book a visit

Three short steps, about a minute.

or call (844) 410-9163

What ICE and DRAIN blinking
actually means.

U-Line places an air sensor in front of the condenser so the control can adjust to the room. When the sensor reads open or shorted, ICE and DRAIN blink together.

U-Line ice machine display · also shown as air temperature sensor error

What to do when ICE and DRAIN blinking shows on the ice machine

Before you book,
in this order.

Each step comes from U-Line's own guidance for ICE and DRAIN blinking on its ice machines. Follow it to the end: the last card says whether this is a visit.

01

Turn the machine off.

02

Check that the front grille is clean and not blocked; a clear grille helps once the sensor is replaced.

03

Book a visit to test the sensor.

Still there?

It usually turns into ice machine bin control repair. Book with the code and the model number.

What not to do

This pattern is about a sensor, not about draining, even though the DRAIN lamp blinks. DRAIN blinking alone is Er16, a slow drain.

What you may
notice with it.

The ice machine problems ICE and DRAIN blinking tends to arrive with. Answer these at the ice machine before anyone is booked.

All problems

Where ICE and DRAIN blinking usually leads

Ice machine bin control repair.

Bin thermostat, paddle, curtain switch or ice-level sensor · low.

In U-Line's own words

When the air temperature sensor in front of the condenser is disconnected or shorted.
U-Line URNP115 15-inch nugget ice machine user guide

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. U-Line 1 Class RNP115 and Outdoor ONP115 nugget ice machines, which report through the ICE, NO WATER and DRAIN lamps beside the light button.

U-Line ICE and DRAIN blinking ice machine repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family filling glasses with nugget ice from an ice machine in a large home kitchen.
For the heart of your home.

Questions
about ICE and DRAIN blinking.

Can I clear ICE and DRAIN blinking myself?
Turn the machine off. If it comes back, it needs a visit.
Where is the air sensor on a U-Line nugget machine?
U-Line places it in front of the condenser, where it reads the air the machine draws in.
Does dust cause the ICE and DRAIN pattern on a U-Line?
Dust does not break the sensor, but a clogged grille makes the machine work harder. Clean it while the sensor is being fixed.
Can I run the machine with this pattern?
The control flags the missing reading. Book a visit rather than cycling power repeatedly.

Back to your everyday

Still showing ICE and DRAIN blinking?

A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.

(844) 410-9163 Schedule a repair