U-Line nugget ice machine with ICE and NO WATER blinking: evaporator sensor
The evaporator outlet sensor tells the control how cold the drum is getting, and every cooling check relies on it.
Mon–Sat, 8am–8pm
- Sensors and bin control
- Ice machine bin control repair
- Source: U-Line
Book a visit
Three short steps, about a minute.
or call (844) 410-9163
Loading appointment form…
The appointment form couldn’t load. Please try again.
What ICE and NO WATER blinking
actually means.
The evaporator outlet sensor tells the control how cold the drum is getting, and every cooling check relies on it. When it reads open or shorted, ICE and NO WATER blink together, and U-Line's step is to check the sensor and its mounting and restart after the repair.
U-Line ice machine display · also shown as evaporator temperature sensor error
What to do when ICE and NO WATER blinking shows on the ice machineKind of codeSensors and bin control
A sensor is telling the board something that is not true: a bin control that reads full on an empty bin, or empty while ice spills over the top, a curtain switch stuck open, a temperature sensor out of range, or an eye on a dispenser that no longer sees the cup. Scale and slime on a probe or an ultrasonic sensor cause much of it. Clearing ice piled against the bin control is a safe first step; testing and replacing a sensor is a technician's.
Usually leads toIce machine bin control repair
The thermostat bulb, paddle, curtain switch or electronic eye that senses a full bin, adjusted or replaced so the machine stops and restarts on time.
Shows up asIce Machine Error Code or Flashing Light: What It Is Telling You
An ice machine error code may show as a number on a small display, a pattern of blinking lights on the control board, a colored light on the front, or a machine that stops with one indicator flashing.
MakeU-Line
U-Line ice machine visits in a home bar start at the drain, since a slow line affects both the ice and the floor around it.
SourceU-Line URNP115 15-inch nugget ice machine user guide
U-Line 1 Class RNP115 and Outdoor ONP115 nugget ice machines, which report through the ICE, NO WATER and DRAIN lamps beside the light button.
Before you book,
in this order.
Each step comes from U-Line's own guidance for ICE and NO WATER blinking on its ice machines. Follow it to the end: the last card says whether this is a visit.
Turn the machine off.
Check the water supply only to rule it out; this pattern is about the sensor.
Book a visit to test and refit or replace the sensor.
Still there?
It usually turns into ice machine bin control repair. Book with the code and the model number.
What not to do
This is a sensor pattern, not the warm-evaporator warnings Er01 or Er03. Those appear when the sensor works but reports a temperature that is too high.
What you may
notice with it.
The ice machine problems ICE and NO WATER blinking tends to arrive with. Answer these at the ice machine before anyone is booked.
All problems
Where ICE and NO WATER blinking usually leads
Ice machine bin control repair.
U-Line
ice machines.
U-Line ice machine visits in a home bar start at the drain, since a slow line affects both the ice and the floor around it.
U-Line ice machine repairMore U-Line codes
Sensors and bin control on other makes
Undercounter ice machine
A self-contained ice machine that makes and stores its own ice under a bar, a service counter or a kitchen island, from commercial units to clear-ice models in large homes.
Nugget ice machine
An ice machine that freezes a thin layer inside a chilled cylinder and pushes it out with an auger as soft, chewable nuggets, for clinics, offices, hotels and large homes.
In U-Line's own words
When the EVA temperature sensor at the evaporator outlet is disconnected or shorted.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. U-Line 1 Class RNP115 and Outdoor ONP115 nugget ice machines, which report through the ICE, NO WATER and DRAIN lamps beside the light button.
U-Line ICE and NO WATER blinking ice machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about ICE and NO WATER blinking.
Can I clear ICE and NO WATER blinking myself?
Why does my U-Line nugget machine stop with ICE and NO WATER blinking?
Can a loose sensor clip cause this on a U-Line?
Will the machine restart on its own after this pattern?
Back to your everyday
Still showing ICE and NO WATER blinking?
A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.