A white drain line running from the base of a stainless ice machine bin down to a floor sink, a clear air gap above the sink, the floor around the ice machine dry.

Viking blank display: the drain pump safety has cut power to the ice machine

On drain-pump models, a restriction in the drain lets the pump reservoir overfill, and a safety switch removes power from the machine to prevent flooding.

(844) 410-9163

Mon–Sat, 8am–8pm

  • Drain and pump
  • Ice machine drain and pump repair
  • Source: Viking

Book a visit

Three short steps, about a minute.

or call (844) 410-9163

What Blank display (no icons)
actually means.

On drain-pump models, a restriction in the drain lets the pump reservoir overfill, and a safety switch removes power from the machine to prevent flooding. Power returns by itself once the level falls; the machine then chimes, runs a self-test and shows OFF.

Viking ice machine display · also shown as Power interruption, Drain pump high-limit

What to do when Blank display (no icons) shows on the ice machine

Before you book,
in this order.

Each step comes from Viking's own guidance for Blank display (no icons) on its ice machines. Follow it to the end: the last card says whether this is a visit.

01

Check the floor around the machine first; if water is spreading toward an outlet, stay clear, switch the breaker off from a dry panel and close the water supply valve.

02

With the area dry, check the drain line for kinks, make sure it ends in an open drain and that the vent tube on the back is open.

03

Wait a few minutes for the pump to empty; if the display stays blank with a clear drain, book a visit.

Still there?

It usually turns into ice machine drain and pump repair. Book with the code and the model number.

What not to do

A blank display is not always a dead control board on these machines. It is also not Sabbath mode, which darkens the display but keeps the machine running and can be undone with the power icon.

Where Blank display (no icons) usually leads

Ice machine drain and pump repair.

Drain line clearing, air gap, drain pump, float and check valve · low to moderate.

In Viking's own words

Power interruption can be detected when no icons are visible in the display area of the user interface
Viking FIUI5152D professional undercounter ice machine Install / Use & Care manual Viking FIUI5152D professional undercounter ice machine Install / Use & Care manual

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Viking FIUI5152D and FIUI5152DADA clear-ice machines with the built-in drain pump.

Viking Blank display (no icons) ice machine repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family filling glasses with nugget ice from an ice machine in a large home kitchen.
For the heart of your home.

Questions
about Blank display (no icons).

Can I clear Blank display (no icons) myself?
Check the floor around the machine first; if water is spreading toward an outlet, stay clear, switch the breaker off from a dry panel and close the water supply valve. If it comes back, it needs a visit.
My Viking ice machine went dark and came back on with a chime. What happened?
That matches the drain pump safety: power was cut while the reservoir was too full, then restored with a startup chime and self-test.
How do I test the drain on a Viking clear-ice machine?
Viking's check is to turn the machine off and pour 3 quarts of water slowly into the bin; it should all drain without the display going dark.
What causes the Viking drain pump safety to trip?
A kinked or overlong drain line, a drain that is not open, or a blocked vent tube on the back of the machine.

Back to your everyday

Still showing Blank display (no icons)?

A booking with a code goes further when it carries the light or code copied as it appeared, the model and serial off the data plate, and a word on whether cubes still fall into the bin. With those three in hand, our office can match the probable part to your machine the same afternoon.

(844) 410-9163 Schedule a repair